I upgraded from a 7" to 8.4" Uconnect (factory new radio which came with software version 21.10 installed) on my '18 Sport S.
This week I installed a Tazer mini W/ the Beta update 11.2.1 to get ORP.
ORP works with the exception that it doesn’t show the altitude, longitude or latitude settings. It shows - - in those fields. When I access nav/maps and select current location>views GPS it shows the altitude, longitude and latitude.
I did pull fuse 97. After starting the vehicle and accessing ORP it showed the altitude, longitude and latitude settings. I thought it was fixed but when I started the Jeep 10 minutes later those settings only show - - again.
I tried disabling ORP, full Tazer reboot, Reenabled ORP, full Tazer reboot but no luck.
Pulled fuse 97 a couple different times thereafter and still shows - - in those fields.
Any ideas to what may solve this?
Sent from my iPad using JL Wrangler Jeep Forum mobile app
This week I installed a Tazer mini W/ the Beta update 11.2.1 to get ORP.
ORP works with the exception that it doesn’t show the altitude, longitude or latitude settings. It shows - - in those fields. When I access nav/maps and select current location>views GPS it shows the altitude, longitude and latitude.
I did pull fuse 97. After starting the vehicle and accessing ORP it showed the altitude, longitude and latitude settings. I thought it was fixed but when I started the Jeep 10 minutes later those settings only show - - again.
I tried disabling ORP, full Tazer reboot, Reenabled ORP, full Tazer reboot but no luck.
Pulled fuse 97 a couple different times thereafter and still shows - - in those fields.
Any ideas to what may solve this?
Sent from my iPad using JL Wrangler Jeep Forum mobile app