EVO Tire Carrier (Brake and Camera Solution)

dixonk

Member
Love my EVO tire carrier but hated the included brake light relocation bracket and exposed camera. I saw a lot of people opted for the MOPAR relocation bracket to eliminate the need to use the small torx for tire removal, but it still required additional tools and steps to remove the tire. I wanted to clean it up and simplify.

What I came up with: use the EVO brake mount and bend it to mount behind the wheel. Then I took the camera cover and cut it off the stock tire carrier. Trimmed it for a perfect fit and put everything back together. While I was at it I dropped the tire down one notch for better visibility.

IMG_1501.jpgIMG_1502.jpgIMG_1503.jpgIMG_1504.jpgIMG_1505.jpg


Sent from my iPhone using JL Wrangler Jeep Forum mobile app
 

Jdofmemi

New member
Looks good.

I did basically the same thing, but it is on my write up on Wayalife.

Sure better than dealing with the tiny camera bolts to change a tire.

I managed to loose one of them in my concrete driveway, can't imagine dealing with them on a trail with a flat.
 

dixonk

Member
Looks good.

I did basically the same thing, but it is on my write up on Wayalife.

Sure better than dealing with the tiny camera bolts to change a tire.

I managed to loose one of them in my concrete driveway, can't imagine dealing with them on a trail with a flat.

My camera is currently being held on by only 2/3 screws lol. No idea what happened to the 3rd.


Sent from my iPhone using JL Wrangler Jeep Forum mobile app
 

Top