Ok. Ill try it. Thanks.With the exception of the exhaust loop, I would think that this engine skid should work for a 2.0T as well.
Sent from my SM-G930V using JL Wrangler Jeep Forum mobile app
Ok. Ill try it. Thanks.With the exception of the exhaust loop, I would think that this engine skid should work for a 2.0T as well.
Good info. Just found out from Evo they don't have one for the 2.0T. Be they said I should call back in a few weeks.Probably wouldn't hurt to call EVO first to verify as much but so far as I know, the motor mounts are the same and that's what the skid ties into.
Good day -
I pulled the trigger and got the armor for the loop but... as I was doing the install and completed the battle with the alignment of the hole with the other EVO plate (over the oil pan), my bolt, the one on top of the one for the arm was too short... I mean, I managed to get the nut started but didn't feel like it would be long enough to accommodate the width of the EVO plate.
Has anybody else experienced this?
What is your suggestion?
I have watched Eddie's video a few times and I cannot see any mentions on this. How about the rest of you?
Life is good... staying home and wrenching