Results 1 to 1 of 1

Thread: Evo mfg jeep jl d44 m210 advantec truss and c2 end forging axle kit

  1. #1
    EVO MFG Representative kingsize's Avatar
    Join Date
    Nov 2017
    Location
    Simi Valley
    Posts
    69

    Evo mfg jeep jl d44 m210 advantec truss and c2 end forging axle kit

    EVO.jpg

    EVO MFG JEEP JL D44 M210 ADVANTEC TRUSS AND C2 END FORGING AXLE KIT

    EVO-245.jpg

    The EVO MFG JL Dana 44 ProTek Front Axle Truss is specifically designed
    to give your front axle ample strength to prevent deflection and support
    the brittle FAD/CAD casting that is integrated into the front axle and
    prone to failure. The included ” steel differential bridge connects
    left and right truss sections over cast differential center section
    giving a extremely strong one piece integrated truss system covering the
    entire axle end to end. This product is manufactured from 1/4” Laser
    cut steel and CNC press brake formed in strong one piece sections that
    minimize excess heat and weld shrinkage. Less heat, less warping, easier
    and faster install.
    The included EVO MFG JL C2 Axle Gussets are designed to backbone the
    axle end forging "Cs" with CNC formed 3/16" laser cut steel on both
    upper and lower axle Cs keeping them supported and alignments in check.
    Wiring retainers included keeping a clean wiring layout.

    EVO-245 EVO MFG JEEP JL D44 M210 ADVANTEC TRUSS AND C2 END FORGING AXLE KIT
    Last edited by kingsize; 03-08-2019 at 05:45 AM.
    From a Champ to a Chump in just one bump!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •