Evo mfg jeep jl d44 m210 advantec truss and c2 end forging axle kit

kingsize

EVO MFG Representative
Supporter
EVO.jpg

EVO MFG JEEP JL D44 M210 ADVANTEC TRUSS AND C2 END FORGING AXLE KIT

EVO-245.jpg

The EVO MFG JL Dana 44 ProTek Front Axle Truss is specifically designed
to give your front axle ample strength to prevent deflection and support
the brittle FAD/CAD casting that is integrated into the front axle and
prone to failure. The included ¼” steel differential bridge connects
left and right truss sections over cast differential center section
giving a extremely strong one piece integrated truss system covering the
entire axle end to end. This product is manufactured from 1/4” Laser
cut steel and CNC press brake formed in strong one piece sections that
minimize excess heat and weld shrinkage. Less heat, less warping, easier
and faster install.
The included EVO MFG JL C2 Axle Gussets are designed to backbone the
axle end forging "Cs" with CNC formed 3/16" laser cut steel on both
upper and lower axle Cs keeping them supported and alignments in check.
Wiring retainers included keeping a clean wiring layout.

EVO-245 EVO MFG JEEP JL D44 M210 ADVANTEC TRUSS AND C2 END FORGING AXLE KIT
 

Last edited:
Top