Points of reference for leveling a lift?

Hello all,

Have a 2.5” EVO Enforcer lift. After adding rear tire, gear, winch, etc... things have sagged a bit front and rear.

Are there any common points of reference either on the frame, body, fenders front vs rear that I can use to compare to know how much of a spacer to add?

I wasn’t sure if the bottoms of the JL frame rails front and rear are horizontal/inline On the same horizon, lol) if that makes sense?

Rear===——===Front [emoji6][emoji23][emoji6]

Thx!


Sent from my iPhone using JL Wrangler Jeep Forum mobile app

I measured from the center of the wheel hub to the bottom of the fender before, and after I installed my lift.

Yeah, I didn’t take any measurements before the lift was done or right after before any gear was installed.

Likely I’ll just add a 1/2” or 3/4” spacer in the rear and call it good.


Sent from my iPhone using JL Wrangler Jeep Forum mobile app

This might help you out

https://jlwrangler.com/showthread.p...the-Actual-Amount-of-Lift-on-Your-JL-WRANGLER

wayoflife said:

This might help you out

https://jlwrangler.com/showthread.p...the-Actual-Amount-of-Lift-on-Your-JL-WRANGLER

Click to expand...

Bingo, Thank you sir...! [emoji1360][emoji1360][emoji1360]


Sent from my iPhone using JL Wrangler Jeep Forum mobile app