Changing winch line

Jdofmemi

New member
That is what I did to my VR10

I also changed the anchor bolt. I can't remember for sure, but I think the one with the steel cable was too short.

I just took it in to the hardware store and found the right size with a rounded head. I also added some Gorilla tape over the connection to give a nice smooth place for the second layer of rope, since the anchor end is a bit rough.

I had plenty of room for the full 100 ft of new 3/8 rope.
 

wayoflife

Administrator
Staff member
You technically don't even need a new fairlead. If you're rollers have never been used, you can just use it. If it has, you can replace the rollers with new synth friendly ones.
 

Top