tobyw
Member
First off, I am well aware that these are not the ultimate in strength or protection. However, for my use case they will be sufficient. With that out of the way, here are some pictures of how I augmented my factory Rubicon sliders.
I started with some 1-1/2" x 0.120" tube:
Then I mocked it up on the Jeep:
When I was happy with it, I pulled the slider and finished the welding up on the bench:
A quick rinse-and-repeat for the passengers side, and then a coat of paint to match my front bumper:
I started with some 1-1/2" x 0.120" tube:
Then I mocked it up on the Jeep:
When I was happy with it, I pulled the slider and finished the welding up on the bench:
A quick rinse-and-repeat for the passengers side, and then a coat of paint to match my front bumper:
