Search:

Type: Posts; User: scoobycarolanNC

Page 1 of 14 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    28
    Views
    11,211

    Sticky: BFG KM3 275/70r18 34psi on the dash / 32 on arb...

    BFG KM3 275/70r18
    34psi on the dash / 32 on arb deflator
    2500 miles
    31.25” (should’ve been 33.2)
  2. Replies
    25
    Views
    3,852

    I have an early build and broke one of my LED...

    I have an early build and broke one of my LED taillights. When I looked it up there's been multiple revisions to the part number. On the side I replaced I can definitely see a reverse light on the...
  3. Replies
    21
    Views
    1,014

    If you look online you can buy the mopar control...

    If you look online you can buy the mopar control arms from their 2.5" lift. Mine were $65 shipped new. Gives you a bit of extra length but no hassle for setup and maintenance. My Sahara's caster...
  4. Replies
    20
    Views
    3,002

    Thats a great article, thanks for sharing it! In...

    Thats a great article, thanks for sharing it! In the comments someone mentions using a bypass cable to get around the SGW which is what AEV uses in the procal snap. You insert 2 leads into empty...
  5. Replies
    10
    Views
    595

    You'll totally be fine after a while. Just make...

    You'll totally be fine after a while. Just make sure you're under 5mph when shifting into 4lo. I screwed up a couple times and its unplesant to say the least.
  6. Replies
    10
    Views
    806

    How the heck did I miss all that! Scroll further...

    How the heck did I miss all that! Scroll further down in the manual and read about Electronic Roll Mitigation. It sounds like that might be kicking in during extreme climbs.
  7. Replies
    10
    Views
    806

    You said 4lo, you remember what gear & rpm? Maybe...

    You said 4lo, you remember what gear & rpm? Maybe the computer limited the engine because of that?
  8. Replies
    10
    Views
    806

    It sounds like the transmission shifted and...

    It sounds like the transmission shifted and couldn’t get in the next gear or something. I remember Eddie had something similar happen in an early video & warned to do climbs in M and not D. Maybe the...
  9. I’ve got that one it won’t do the trick. You need...

    I’ve got that one it won’t do the trick. You need this. I got mine at Home Depot with a huge battery for $250

    https://www.milwaukeetool.com/Products/Power-Tools/Fastening/Impact-Wrenches/2769-20
  10. Replies
    33
    Views
    2,030

    I read that the sport diesel gets a d44 front end...

    I read that the sport diesel gets a d44 front end so that’s pretty dope as a base builders model.
  11. Replies
    3
    Views
    684

    Clean your seals & there’s stuff you can put on...

    Clean your seals & there’s stuff you can put on them. Give it a shot.
  12. Replies
    8
    Views
    932

    They’ll be different widths. You need a pair of...

    They’ll be different widths. You need a pair of rubicon take offs.
  13. You got an official notice for a track bar...

    You got an official notice for a track bar recall? I want one!
  14. Replies
    12
    Views
    1,487

    Probably too much toe out. You can’t go by the...

    Probably too much toe out. You can’t go by the factory specs anymore on the rack. Use Eddie’s guide & video to check it yourself.
  15. Yup. That was when I was stock & now I’m on 33s...

    Yup. That was when I was stock & now I’m on 33s and a 2” spacer lift with longer control arms. It took a bit to dial in the alignment but it’s good.
  16. Replies
    36
    Views
    3,120

    I emailed them last night. Front track bar drops...

    I emailed them last night. Front track bar drops in October. I have an order for a Rancho, but it’s backordered. I’m gonna wait and avoid having a jam nut. I like synergy’s side bolt adjuster design.
  17. How do I tell if I have a flat spot?

    BFG KM3s 285/70r18: I have this annoying bounce in the rear like I have an out of balance tire. I’ve gone back over my lift & had Discount tire rebalance and rotate. I’ve locked the brakes up 2-3...
  18. Will you ship em?

    Will you ship em?
  19. Replies
    9
    Views
    843

    The Mopar hard plastic floor mats have you remove...

    The Mopar hard plastic floor mats have you remove the carpet, then clip into the floor drains. I’ve hosed out my front seat foot wells more than once. My sidesteps seem to catch most of the mud I...
  20. Replies
    6
    Views
    597

    When I brought my 2018 to the dealer to get the...

    When I brought my 2018 to the dealer to get the deadspot in my steering diagnosed they replaced my whole steering box. When I looked the part# up on line it had been redesigned FIVE times.... Now...
  21. That’s pretty cool nice work. How much does it...

    That’s pretty cool nice work. How much does it move it?
  22. So I toed it in a bit after measuring the front &...

    So I toed it in a bit after measuring the front & rear width, centered the steering wheel better, & set the warm pressure to 32psi & it’s so much better. Flew right up to 80-83mph & tracked pretty...
  23. Thanks bud! I went over almost every bolt today....

    Thanks bud! I went over almost every bolt today. I painted tag lines on em originally and put the torque wrench on a few to double check. I just rewatched Eddie’s track bar video and he casually...
  24. Help using my alignment sheets to fix steering.

    Hey everyone,
    Since adding a 2” spacer, 33” tires, and the control arms from the mopar 2” lift I still just can’t get my steering feeling as great as it did. Honestly, it was perfect after I had...
  25. Replies
    7
    Views
    681

    Spicer has a FAD delete kit that costs $100. I...

    Spicer has a FAD delete kit that costs $100. I saw it on their site & on quadratec but there are no photos or details. On quadratec it has the welder icon so I’d imagine it’s something serious.
Results 1 to 25 of 348
Page 1 of 14 1 2 3 4