Recent content by texasbryan

I ended up adjusting the tension under the center console to get it to work. I still don’t understand what happened. Oh well.

I also put in some coil spacers so I needed to drop the axle enough to free up the springs. You can see in the picture below that the cable is very close but not quite long enough. Keep in mind the other side is already connected and the handle in the cab is all the way down. So if I force this...

I disconnected the emergency brake on my JL 392 in order to replace the shocks. I did reroute the cables to make future axle drops easier. Now, I can't reconnect them for some reason. The connection tabs on the brakes are still held out with vice grips on each side. When I connect the cable on...

I recently installed 37 inch Ridge Grapplers on my JLUR that has a 2.5" Teraflex lift and a full width Go Rhino front bumper. I cut off about 2/3" off the end (side) of the bumper to prevent rubbing but I may need to cut off more. I'm thinking at full stuff with a slight turn it may still rub...

+10 or -18 Offset? Need help picking the right wheels. I am considering the Black Rhino Chase wheels for my JLUR with a 2.5 in lift. My choices are: 17x8 with +10 Offset or 17x9.5 with -18 Offset I want to run 37x12.5R17 tires (Nitto Ridge Grappler). Will both wheels fit fine with zero...

I need a lift! The only thing this rig needs is a Dynatrac Endurosport!

Does anyone make a 1 or 1.5" lift for the JL? I have seen some leveling kits but I'm wanting to maintain the factory rake while raising my Rubicon 1 to 1.5 inches. Just enough to make sure I have good clearance with my 35 inch tires. Would coil spacers typically be the best way to achieve this...

Hey guys, How much stock should I place in the load rating of a tire? I am looking to go up to 35’s on my JLUR. Based on comfort, I would prefer a C load rating. However, as you guys probably know, it’s tough to find a 35” tire with a C rating. I am looking at getting some Nitto Ridge...