I have a set of rim/tires/sensor combo that I would like to get rid off.
I have 600 miles on them.
Would like to get 1300 for the whole set.
I can ship freight if needed but not sure how much that will cost.
I can help installing them if needed too.
I am in the Denver area.
Lol
Now I have to agree.
I thought was going to be easier and found few spots to be a little challenging (to pick a line because I was bymiself) but rewarding at the end.
Lucky enough I joined jeepers on the way down and followed their lines.
Yes, Hiked around the plane crush.
Here a few...
Got myself into a bit of flexing today and I rubbed the rear diff twice but nothing else.... mostly because two wrong lines I took.
Sent from my Pixel 3 XL using JL Wrangler Jeep Forum mobile app
Here are few shots...sorry is a bit dark when I finished.
I have the angle down version and is roughly 1" drop (bottom of square section to bottom of round pipe. 19-3/4 vs 18-3/4 roughly).
They come outward roughly 4", a little less then the fender and I really like them.
Install was easy...
I apologise for the quality of the picture but finally....
I will get better shots over the weekend for sure.
...and hello from CO!
Sent from my Pixel 2 XL using JL Wrangler Jeep Forum mobile app
I am not 100% sure if they are frame mounted because I didn't install them yet.
Here is a pic where you can clearly see all the mounting points.
Probably next week or so the will go on the Jeep and if you would like I can follow up.
They told me they are strong enough to be used with a...
This is my "solution" for now.
12.9 bolts with two nuts to lock them in place without tightening the bracket too much.
Hopefully they stay put and don't spin around damaging the bracket until we get a proper bushing.
IMO the bushing installed is too thin and too short, allowing the bracket to...
Same thing happened to me....
I noticed the bracket "bending" on the rear while torquing @ 80 but was too late.
Didn't really noticed anything in the front but the same thing happened.
I just removed the shocks and I have bended bolts and bushing crushed on the lower side.
The top side is...