Piginajeep
Moderator

Sent from my iPhone using JL Wrangler Jeep Forum mobile app

The transfer case is still mechanical but so far as I know, the new automatic transmission is shift by wire now. Pros, the new 8-speed is...

On a JL, not only are the shafts different lengths, the passenger side is totally different due to the FAD.

This might help you out :) https://jlwrangler.com/showthread.php?829-WRITE-UP-HOW-TO-Determine-the-Actual-Amount-of-Lift-on-Your-JL-WRANGLER

LOL!! Thanks! I guess I never did post it up here. I suppose I should :crazyeyes:

Sorry, I haven't had a chance to test them out but of the Cooper tires I've run, they all have performed well for me.

Well that's a bummer. I decided to go with an ARB anyway being that I've had a lot of problems with the e-locker in the past. I'm just using the aux...

Try telephoning them. Sent from my iPhone using JL Wrangler Jeep Forum mobile app

My employee sent me the pic. It was gone before I arrived. 2019 MP 2012 JK8 1958 FC170 1954 M38A1

In Mojave today,., 2019 MP 2012 JK8 1958 FC170 1954 M38A1

What I can tell you is that I didn't install any spacers on my KMC wheels and really, you shouldn't need them either. From what I understand they do...

What you need to know is that MOST lift kits yield WAY MORE LIFT than what is advertised and this is especially true on 2-doors. In other words, a...

That, I'm not 100% sure off. I'm pretty sure the actual connector is a bit bigger on the JL but the wiring should be the same.

Not sure but if KMC offers them, it wouldn't hurt to run.

I used these https://amzn.to/2NmWrCa Hope that helps you out.

Awesome! Welcome to JLWRANGLER. Post up some pics when you get a chance :)

LOL - fun stuff

LOL!! This ^^^^

You technically don't even need a new fairlead. If you're rollers have never been used, you can just use it. If it has, you can replace the rollers...

Or directly from Off Road Evolution... https://www.offroadevolution.com/product-category/bumpers-armor-skids/ Sent from my iPhone using JL...

Wow, that just sucks. I am so sorry to hear that. At this point and time, I think the very least they can do is cover your payments for all the time...

Your driveshaft u-joints should be held on the yoke using snap rings. They should be sitting on top of the bearing caps and are super easy to...

If you're running full circle clips, you most likely will NOT need to do a field repair. 99% of the front axle shaft u-joint failures I've seen have...

The front axle shafts use 1350 u-joints and the one u-joint on the front drive shaft is a 1330. I personally prefer Neapco u-joints being that they...